A . the power stroke
B . the compression stroke
C . low load operation only
D . periods of standby
[单选题]The oil quantity for bearing lubrication should be applied in such an amount as to be sufficient to carry away the () caused by the friction at the bearings.A . acidsB . additivesC . heatD . gear
[单选题]Mist detectors used on large low-speed main propulsion diesel engines monitor and check for the presence of ().A . fuel oil vapor at the sludge tank ventB . unburned fuel vapors in the scavenge air receiverC . lube oil vapors in the crank caseD . lub
[单选题]Oil pressure in the lubrication system is () the static sea water head to ensure that sea water () the stem-tube.A . lower than;can lubricateB . lower than;can coolC . higher than;can enterD . higher than ;cannot enter
[单选题]Oil is supplied to the cylinder wall and () by means of mechanical lubricators.A . the cylinder coverB . the piston ringsC . the piston crownD . the piston skirt
[单选题]In addition to lubricating, cylinder oil assists in forming a gas seal and contains () which clean the cylinder liner.A . additivesB . waterC . greaseD . acid solutio
[单选题]In low - speed network ,it is usually adequate to wait for congestion to occur and then react to it by telling the source of packets to slow down. In high - speed networks, this approach often works poorly, because in the(71)between sending the notif
[单选题]In some designs the cylinder oil is timed so that the oil injects only on the ().A . piston crownB . piston grooveC . piston skirtD . piston ring belt
[单选题]The rate of cylinder lubricating oil metered to each cylinder of a large low-speed main propulsion diesel engine is ()A . the same, whether at sea, or during maneuveringB . adjusted during each hour of operation while at constant RPMC . higher at sea
[单选题]In low-speed network,it is usually adequate to wait for congestion to occur and then react to it by telling the source of packets to slow down.In high-speed networks, this approach often works poorly, because in the (71) between sending the notificat
[单选题]In low-speed network, it is usually adequate to wait for congestion to occur and then react to it by telling the source of packets to slow down. In high-speed networks, this approach often works poorly, because in the(71)between sending the notificat